Maintenance and care practices for boltless shelving and racks are mainly done to enhance durability, functionality, and safety (for people and goods).
Safety is paramount in any work environment not only for the employees, but also for the goods you intend to store in your storage facility. Primarily, durable boltless shelves will offer you service for a long period.
There are many activities you can carry out to maintain and care for your boltless shelving and racks. Essentially, most of these activities are categorized into three major practices including;
- Regular inspection
- Cleaning
- Addressing wear and tear
In this article, we are going to discuss the various maintenance and care activities under each major category.
Extending the Lifespan of Your Boltless Shelving
Maintenance and care practices not only help reduce the rate of boltless shelving failure, but also extend its overall lifespan (durability).
In order to extend the lifespan of your boltless shelves, it is paramount to carefully follow the manufacturer’s loading guidelines. In this case, heavier loads go on the bottom shelves and the lighter ones to the top for general stability purposes.
It would be best to analyze the load distribution on the boltless shelving to prevent uneven loading or cases of overloading; overloading causes structural failure, while uneven loading may cause instability.
Finally, ensure that you put regular cleaning and inspection routines in place to assess and improve the structural health of your rivet racks.
Regular Inspection and Checkups
Regular inspection and checkups involve the periodic analysis of the industrial shelving in your warehouse.
Intrinsically, inspection routines account for the overall health of the boltless rivet shelving you have installed in your storage facility. Regular inspection will help you determine the any part of the racking system that requires servicing or replacement.
Some of the common activities that comprise regular inspections and checkups include:
· Routine Checks
It would be best to have a regular inspection schedule that allows you to assess the condition of your rivet racks. Basically, routine checks enable you to catch and address wear, damage, or malfunction in time and help prevent failure.
· Checking Connections
Checking connections helps ensure that all the linkages between the beams, uprights, and shelves are strong.
Basically, boltless rivet racks has interlocking connections that may loosen over time. As such, it would help to tighten any loose connections as per the required standards.
· Test for Stability
Testing the stability of your shelves is as simple as shaking the shelving unit. Wobbling, squeaking, or shaking is an indication of instability.
Addressing Wear and Tear
Constant loading and unloading cause a pressure difference that subjects the rivet racks to wear and tear after some time. In order to properly address wear and tear, follow the procedure outlined below:
· Identify Signs of Wear and Tear
Diagnosis helps identify cracks, bends, disconnections, and any other visible signs of wear and tear.
· Repair the Defects
Once you identify the wear or tear, you should replace the accessory or the damaged component immediately to retain the rivet rack’s stability and functionality.
Since the rivet rack parts are readily available, the manufacturer or your distributor can easily avail the necessary parts.
· Reinforce the Unit
Some rivet racks are under consistent loading (especially when the warehouse is busy) and can be subject to overloading.
As such, installing additional supports enhances the load-bearing capacity of the entire rack.
Cleaning
Cleaning is the primary maintenance and care practice for most surfaces and storage units. The cleaning practices for most racks are almost similar, with slight variations depending on the material used to manufacture the rivet shelving.
First, dust the surface of your racks using a cloth to remove dust particles and solid debris.
Then, use a damp cloth and detergent to remove the remaining stains and dirt; avoid soaking particle board rivet racks to prevent warping.
Finally, dry the rivet rack shelving to prevent rusting on metallic surfaces as well as the warping and rotting on particle board surfaces.
Conclusion
Proper maintenance and care practices, as discussed above, help extend the lifespan and efficiency of your boltless rivet racks. Ensure you invest considerable resources in proper shelving and racks maintenance.
